View Single Post
Old 10-25-2021, 01:03 PM   #5
Board Member
Join Date: Aug 2006
Location: E(Seattle!Vancouver! San Francisco!LA!) Helsinski

I made VDO gauge panel for my 121 long time ago. I took that bezel from instrument cluster, made about 4 mm thin wooden panel. Lay out of gauges were like this:
Gas and temp were smaller, rpm and speedo in the middle.

I had to cut that trim list and maybe 20x100 mm from dash board to make some space for rpm gauge and speedo.

Today I would have a little different approach. But, I was 18 then.
OttoB is offline   Reply With Quote