• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

240 IPD rear anti sway bar

RickATL

Member
Joined
Jan 21, 2015
Location
Atlanta
Looking for some help on the proper install of the rear anti-sway bar.



There is a bolt with a very thin top. Should this go behind the control arm and then through the anti sway bar. I don't see how it can because the ball joint is in the way. Is the back of the sway bar just supposed to sit against the bracket?
 

Attachments

  • 20220315_143425.jpg
    20220315_143425.jpg
    195.7 KB · Views: 69
Last edited:
#1 Are we looking at a 240?

#2 are you talking about the carriage bolt that IPD gives you even though the stock one is long enough / works?


yes, its a 240,


The bolt provided by IPD is short and very thin at the top. I can't tell its its meant to slip in between the bracket or go behind the the control arm and through to the anti-way bar.
 
Read the instructions like 5 times, its not clear on whether it goes through the control arm or slides behind the bracket. I even tried IPDs forum, but no answers.
 
Back
Top