2manyturbos
Moderator
- Joined
- Mar 8, 2003
- Location
- Monroe, OR USA
Btw, is that a 940 pedal assembly you are using! I have seen one of them on a 240?
No. Simon is just using his 7-9 to make it clear what he is talking about.
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Btw, is that a 940 pedal assembly you are using! I have seen one of them on a 240?
Great I will take a look at this!Yes I was just showing you how to wire the other vacuum switch with that one pic is real clear. Basically you'd just need another plug thing and wire it in line with the other one like in the pic.
[/url]
how's the swap going?
Going slow. Been all over looking for the pin to hold the clutch cable to the clutch pedal.
Yes, you only jumper the one wire. The trans mounts are different but can be interchanged. The automatic one is similar to what is used for an M46. The small rectangular mount for the M47 is a bit smaller than the other mounts.