Hi everyone
Embarking on a bit of a project here... putting an 850 t5 lump into my bmw e30. I am going to have to custom make a sump as the 850 sump sits too high and i wont be able to shut the bonnet, and if i were to chop a 960 sump up i would have to mess around with ARB and subframe position to fit a rear hump sump.
My question is to you lovely people... does anyone have the measurements/ a scan/ profile of a whiteblock sump flange i could use as guidance to laser cut... would give me a base to make a front hump sump off of!
Will also need to relocate the oil filter... any suggestions as to where to take to oil feed from and return port?
Hope im making sense
Embarking on a bit of a project here... putting an 850 t5 lump into my bmw e30. I am going to have to custom make a sump as the 850 sump sits too high and i wont be able to shut the bonnet, and if i were to chop a 960 sump up i would have to mess around with ARB and subframe position to fit a rear hump sump.
My question is to you lovely people... does anyone have the measurements/ a scan/ profile of a whiteblock sump flange i could use as guidance to laser cut... would give me a base to make a front hump sump off of!
Will also need to relocate the oil filter... any suggestions as to where to take to oil feed from and return port?
Hope im making sense