Holset HX25?

marchul · Apr 30, 2008

How much bigger is this than the stock t3 on our cars? Does it use a t3 flange? Im looking for a new turbo, and I found this one with a good price. Oh and just out of curiosity, what did this come on?

marchul · Apr 30, 2008

Just found a kkk off of a volvo... Only the s60 Rs used kkks right? What exhaust flange are they?

mfpmax · Apr 30, 2008

I saw a HX25 on Ebay recently...I'd say its smaller since the HX30 is about T3 sized.

marchul · Apr 30, 2008

Hmm, so from what I understand... all Cummins 6BTs used hx35s right? lol yeah Im on ebay...

lolwagon · May 2, 2008

marchul said:
Just found a kkk off of a volvo... Only the s60 Rs used kkks right? What exhaust flange are they?

you want my downpipe, exhaust mani, oil fittings...yadda yadda? hollar at me...hollar at RvolvoR that is

amargill19? · May 2, 2008

this thread is racist

marchul · May 2, 2008

lolwagon said:
you want my downpipe, exhaust mani, oil fittings...yadda yadda? hollar at me...hollar at RvolvoR that is

Is all of that for the kkk? Im not going to get it...

Turbo B · May 5, 2008

I can give you a little input on a HX25W as I just installed one on my MGB. Previous turbo was a Garrett GT2052.

HX25 uses a T25 inlet flange. Compressor wheel isn't much bigger than the GT20 but it flows around 0.22kg/s or 30lb/min.

Spool is quick on the 9.5:1comp 1.9litre engine. Not as quick as the GT20 by a long shot, but I would not run the turbo on anything over 2 liters. I read that the ford 2.3 liters were getting about 300whp out of them.

hockey930 · May 5, 2008

^ mg moves pretty good with the 25, spools very quick. But then again what doesn't spool quick according to me.

Holset HX25?

marchul

quarter ricer

marchul

quarter ricer

mfpmax

New member

marchul

quarter ricer

lolwagon

New member

amargill19?

Barry McCockiner

marchul

quarter ricer

Turbo B

New member

hockey930

300+ Member