the poi
Has been
- Joined
- Jan 5, 2003
- Location
- Pasadena, CA
Any recommendations for M10 ball joints or rod ends with a ****load of misalignment? I'm trying to make a swaybar endlink, but I'm getting bind with two 24 degree rod ends. Heres a picture of what I had before:
It's a cut in half and coupled together stock guy, and I'm not comfortable with the longevity, mostly cause I'm welding reeeeal close to a grease filled ball joint.
Any suggestions for balljoints with an M10 stud? I could get some more with misalignment bushing but I don't want to go down to an M8 stud on the shock/swaybar, nor increase the tube to accommodate an M12 rod end (and the M12 rod ends have less motion anyway!)
It's a cut in half and coupled together stock guy, and I'm not comfortable with the longevity, mostly cause I'm welding reeeeal close to a grease filled ball joint.
Any suggestions for balljoints with an M10 stud? I could get some more with misalignment bushing but I don't want to go down to an M8 stud on the shock/swaybar, nor increase the tube to accommodate an M12 rod end (and the M12 rod ends have less motion anyway!)