B6294T + B6304F on 960! - Page 2

VB242 · 03-02-2022, 08:26 AM

I thought one of the BMW 6 cylinder engines had an exhaust manifold that fits?

Polar971 · 03-04-2022, 01:22 PM

Quote:

Originally Posted by 244tiCanuck

The later 5 cyl exhaust manifolds are cast stainless, they weld very nicely. You must TIG weld them for it to work well, with a 309L rod. Build up the weld a bit so you can grind it down, hit the area with a needle scaler and nobody who doesn't know would know it's not a factory piece.

THanks!!! the XC90 B6304T4 its the same maybe?

Polar971 · 03-04-2022, 01:23 PM

Quote:

Originally Posted by VB242

I thought one of the BMW 6 cylinder engines had an exhaust manifold that fits?

Mybe the M50 M52, but u need make a new position holes...

Polar971 · 03-04-2022, 01:27 PM

I have been cubing the cylinder head and in principle to leave it at 8.5 CR I have to remove 8.1cc of material... I know that removing it from the cylinder head is dangerous because of the Squish issue... But I realise that the difference between one chamber and the other is mainly the upper and lower cooling areas, I wonder if I can remove material from there without affecting anything and without damaging the engine... pogo foto...

does anyone know how to put the pictures in a forum? bufff is very complicated

Polar971 · 03-04-2022, 01:27 PM

Polar971 · 03-06-2022, 04:31 AM

nobody?

hiperfauto · 03-06-2022, 01:55 PM

Click the 'Share' tab on postimage and copy the 'Direct link' url.

Polar971 · 03-07-2022, 03:32 AM

Thanks

03-02-2022, 08:26 AM	#26
VB242 I.M. Weasel Join Date: Sep 2011 Location: Driving the No Malarkey Bus	I thought one of the BMW 6 cylinder engines had an exhaust manifold that fits? __________________ Living life one day at a time. Stopping to smell the oil slick beneath my Volvos.

03-06-2022, 01:55 PM	#32
hiperfauto The Librarian Join Date: Nov 2011 Location: So Cal	Click the 'Share' tab on postimage and copy the 'Direct link' url. __________________ 240 Alcantara Shift Boot Cover (164 & 72- 140 too) Rare, Race & R-Sports Parts Colored B/S Brake Hoses 140/160 and more Volvo Advertising Stuff -

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

03-04-2022, 01:27 PM	#29
Polar971 Board Member Join Date: Sep 2020 Location: Mallorca	I have been cubing the cylinder head and in principle to leave it at 8.5 CR I have to remove 8.1cc of material... I know that removing it from the cylinder head is dangerous because of the Squish issue... But I realise that the difference between one chamber and the other is mainly the upper and lower cooling areas, I wonder if I can remove material from there without affecting anything and without damaging the engine... pogo foto... does anyone know how to put the pictures in a forum? bufff is very complicated

03-06-2022, 04:31 AM	#31
Polar971 Board Member Join Date: Sep 2020 Location: Mallorca	nobody?

03-07-2022, 03:32 AM	#33
Polar971 Board Member Join Date: Sep 2020 Location: Mallorca	Thanks