• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

3D Printed Parts Thread

Now that the little rubber feet for 240 gauges are $20/each shipped, I feel like it's an ideal little piece for someone who can print flexible filament.
 
Can't find anywhere 88' 740 euro headlamp trim without washer holes. (This is drivers side). Those grey ones under the washers. Im planning to remove those washers. 1000053733.jpg1000053732.jpg1000053736.jpg
 
Last edited:
Selling cheap parts & files for 240 & 740/940 sun visor clips. Files for the 240 clips existed, but they were bad. Geometries are nailed on these. We also have a great filament for replicating the (odd) color of the original 240 ones.
 
  • Like
Reactions: Dan
Marvelous3 said:
Does anyone sell 3d printed 240 front speaker mounts?
Click to expand...
www.thingiverse.com

Volvo 240 5.25 Speaker Bracket and Grille by propav8r

Here's a design for a speaker bracket and grille that allows the mounting of a 5.25" speaker in a Volvo 240. I haven't printed these to verify fitment yet, so print at your own risk. I'll update this post after I receive the sample prints.The outer four holes of the bracket are designed to take...
www.thingiverse.com www.thingiverse.com

I've printed these successfully for someone. I don't recall hearing feedback on how well the model suited the need.

PM if interested.
 
Schwagon said:
I've got a few prints up on Printables:
Fuse block cover plate and retaining clip that sits in the kick panel
Upper seat belt mounting point cover - A model for this already exists but it did not fit my 89 well at all so I designed my own
Wagon liftgate lock cylinder gasket - My lock cylinder gasket was leaking into the lift gate, so this is a TPU print to replace the gasket. Seems to be working so far.
Click to expand...
Man, I got an stl for the fuse cover knob I need to upload.
Ill have to print myself a door, I got one but its the wrong color and it bothers me, will test this soon thanks.
 
Lots of great contributions here. I've added them to the repository. Thank you everyone!
 
Benjam83 said:
19b2fbf2.jpg
The 740/760 US Spec Headlight bezel "Doors"...

I feel like I've seen some movement in printing these...but because of where they are on the car...I'd think they'd like need to be printed out of some pretty heavy duty material (ABS? Nylon?).

Has anyone had any luck? Or does anyone know of someone who's had luck printing these? Because of so many original ones that are broken, and the european guys snapping up all the US ones, I feel like there'd be a pretty good market for 3d printed replacements...
Click to expand...
I would lwk suck schmeat with proper gusto if someone had made the models for the quad square bezels and the mounts for the 240. I really don't feel like paying 400+ smackaroos for used headlights no matter how rare the part itself is.
 
Jonikopsuka said:
I would lwk suck schmeat with proper gusto if someone had made the models for the quad square bezels and the mounts for the 240. I really don't feel like paying 400+ smackaroos for used headlights no matter how rare the part itself is.
Click to expand...
If anybody in the area has a bezel I can borrow to scan and reverse engineer, I could possible draft models.
 
You must log in or register to reply here.
Back
Top