• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

90s 240dl wagon shudder at low speed

oliverwilson

New member
Joined
Mar 24, 2026
I have a 90 240 wagon that seemingly overnight started shuddering at low speeds. It shudders a little bit on acceleration till around 15mph then goes away completely till slowing down around 20mph and gets progressively worse all the way until stationary.
I did some research and it seems (and looked) like the carrier bearing needed to be replaced, it was hoping like crazy while in drive. But the u joints looked fine, not sure if I should take them off and get a better look though I have new ones already anyway. And the car just had the whole rear end rebuilt this past summer so, front and rear rotors and pads don’t seem to rub visibly or while on a lift so I’m out of ideas
 
I did carrier, and have the parts to do the u joints. As for the mounts from what I can tell they look and feel relatively normal. May replace anyways. But any other suggestions or ideas would be more then welcome
 
I drove it around today to try to get a better feel for where it was, it definitely feels more towards the rear and there’s a squeak coming from the rear as well
 
My 91 needs a trans mount and it feels like its from the rear too- does the squeak happen in time with the rumble? Its rumble is fairly similar to yours, tho it doesnt happen much or at all on decel
 
I replaced the u joints and that seemed to solve the issue
Cool. I'm late to this one, but would have suggested checking them out. My 5spd '92 244 did similar things and I found the rusty seized bit when I took it off and it wouldn't pivot like it should

173891744.jpg


173891745.jpg
 
Back
Top