• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Drunk Monkey 3D Models

Good stuff! Have you printed and tested these parts yet? What material would you recommend?
Yes.
I have both the tube and the TPS adapter on my car now and they seem to work well.
IAT temps seem accurate and there are no vacuum leaks so far. TPS sensor adapter works as intended.

I printed both parts in PETG at 100% Infill.
 
Very nice.

What settings did you print the ASA at?

I have an all metal hot end already but still have the bowden tube set up, not direct drive.
 
In one of my boxes I have a CHMSL I took from a late 240 wagon. The shape of the mounting housing doesn't line up with '83 tailgate metal. I haven't looked too hard at the feasibility of modifying what I have to make it mount vs aiming for something 3D printed, but if I can find it in one of my boxes, would you be interested in figuring out a model?
 
In one of my boxes I have a CHMSL I took from a late 240 wagon. The shape of the mounting housing doesn't line up with '83 tailgate metal. I haven't looked too hard at the feasibility of modifying what I have to make it mount vs aiming for something 3D printed, but if I can find it in one of my boxes, would you be interested in figuring out a model?
Yeah shoot me a message.
 
Back
Top