• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

240 amm plug

To remove the pins in the connector. First peel back the rubber boot and slide it up the wires a bit. Then when you look inside at the contacts on the side that connects to the air mass sensor you'll notice each contact has a small slot next to it. To remove the pin you slide a flat thin piece of stiff metal into the slot. You may have to wiggle it a little. You'll make a locking tab snap free and that will allow the wire to slide out of the connector body. Be careful not to break or otherwise damage the locking tab. If you do damage it you need to install a new contact on the wire.
 
You must log in or register to reply here.
Back
Top