Search results

The trans is out of the car, bellhousing off. The side where I would normally pull the seal has a washer pressed in after the seal. How does this come out with out bending it, because it looks like I need to put it back with the new seal? The parts kit...

On a normal, no LS rear wheel drive car the the pass rear wheel spins first. How about the front wheel cars?

Its mounted by the battery. For the rest of the cool days it will be open downdraft tube. I had to take the batt cable off for a while to reset the brain for the new air flo.

Where do the power wires for the roof motor run?

What goes wrong with the LH 1.0? 1981 or 1982 has a module on the passenger side by the window wash. Symptom=no spark.

The black one is from 91 240 with 5 pin amm. silver is from 94 940T. Why isn't this plug and play? Can I get along with the black and the turbos fuel computer or am I supposed to change plug ends to use the silver?

Does anyone have an idea how best to attach pipe to can? The alu is real thin so it will blow through like when the drain on the bottom was welded.

Is anyone familiar with removing the pins (wires) from the amm plug?

This sticker is on the top of the doner cars aw71 (94-940). Is this volvo original or a rebuilders sticker? It was new looking before I washed the trans.

Like the title says, this will give you quad brake lights for extra safety and visibility on your 240, while keeping the rear fog light feature working, as Volvo intended. The tail lights are spade lugs, so adding a jumper wire or slipping in a diode is easy. Most cars have a driver side "fog"...

The aux fan does not turn on with the A/C any more. Jumpering the plug for the switch in the A/C pipe to the condenser [just below lower radiator hose] makes it work. Does removal and replacement of the switch vent the freon? '91 240

I am replacing the tail shaft bushing. I have it off. I noticed that the PO had this apart [non-mechanical PO, so had a shop work on it??] -- it has the silicone blue gasket maker all around. The car has 109k, verified with carfax. If it is original, the oil hole in the bushing was not in an...

Anyone in Sweden know a place with after market heavy duty springs for sale? In the USA, Groten has scantech and the dealer has stock. IPD used to carry some made in Sweden, but no more.

So, the nut on the spring retainer [rear spring] just spins. When this happened at home, I just blasted it with the welder and continued to take it off. Now it happened at the junkyard. Any ideas for removal?? vicegrips cannot touch it.

What are the reasons for the different temps available?